Elk Foundation: 10 Tips for Processing Your First Elk

Elk Foundation: 10 Tips for Processing Your First Elk
MISSOULA, Mont. — Hunting season is well underway. You finally tag an elk or deer but now the local butcher is swamped, forcing you into a crash course in processing your own meat. Fear not, says the Rocky Mountain Elk Foundation, which offers the following tips and diagram to guide you.

"Many hunters don't venture into butchering until they're forced, either by economics or necessity," said P.J. DelHomme, hunting editor of "Bugle," the Elk Foundation's member magazine, "but once they try it, it often becomes an enjoyable extension of the hunt. Converting a game animal into food is another way to connect with land and habitat and wild places."

1. Hanging meat for aging and tenderizing is usually preferred but if you don't have a temperature-controlled environment between 35 and 50 degrees, the process can be risky. Consider getting the meat cut, packaged and into the freezer ASAP.

2. Wild game can be aged and tenderized later using an alternative process. Remove a package of meat from the freezer and allow it to partially thaw. When the meat is beginning to soften and covered with slushy ice crystals, put a tally mark on the package and refreeze. Then repeat. When a package has three tally marks, it's ready for cooking.

3. The four basic tools for butchering are simple around-the-house tools. You will need a good sharp knife, a whetstone to keep the knife sharp, a hacksaw and a cutting board. You may also wish to use rubber gloves.


4. Cleanliness is crucial. Rinse the skinned carcass (or quarters) and pat dry before you begin cutting. Wash your tools with soap and water before you start and clean your knife after each sharpening. If it's not too cold, set up a cleaning table outside and use a hose with a high-pressure nozzle.


5. The goal is to simply reduce the animal to individual muscles or groups of muscles, per the diagram. Start by removing the legs. Rear legs are jointed and fit into a socket in the hip. Front legs fit onto the chest mainly with muscles and tendons. The rest of the animal basically is ribs, neck and spine, and meat can be filleted from these areas. Remove back straps by slicing down the center of the back and boning along spine outward onto ribs. Don't forget to take the tenderloins from the inside spine.


6. Don't try to make chops. Without professional-grade saws and butchering tools, consider simply cutting meat off the bones to make steaks, roasts, stew meat and jerky. When cutting a muscle into finished pieces, remember to cut across the grain of the meat.

7. Trim away bloodshot meat, connective tissue, membranes, cartilage, fat—anything you don't want to eat—and toss it into a bucket or trashcan lined with a plastic bag. Use another bag or tub for clean trimmings or cuts for grinding into burger. Freeze this bag of meat and take it to your butcher for grinding later when he or she isn't swamped.

8. If you have a vacuum-type food sealer, use it. Otherwise, wrap meat in cellophane and then butcher paper. Double wrapping is better. Mark each package with the date and type of cut. Expect finished meat to weigh less than 50 percent of the animal's live weight.


9. If your deer or elk came from a CWD area, special instructions may apply. Refer to the Web site of the RMEF-supported Chronic Wasting Disease Alliance, www.cwd-info.org, for information.

10. For more information, photos, charts and breakdowns of cuts, go to the RMEF Web page www.rmef.org/hunting and click on "Carnivore's Kitchen."

Recommended for You

Hogs

Quick Tips: How to Spot and Stalk a Hog

Ian Nance - May 28, 2019

Try these tips to improve your wild boar hunting skill set.

News

Game & Fish Magazine Names New Editorial Director

G&F Online Staff - May 23, 2019

Adam Heggenstaller takes over after 14 years with NRA Publications.

See More Recommendations

Popular Videos

Lure Lock Tackle Cases: No-Spill, No-Scent

Glenn Walker talks us through the soy-based technology that makes Lure Lock cases spill-proof and scent-proof. With Game & Fish Editorial Director Adam Heggenstaller at ICAST 2019 in Orlando.

Berkley's New Terminal Tackle

OSG's Lynn Burkhead and Chad LaChance, host of World Fishing Network's Fishful Thinker television show, talk about Berkley's new innovative terminal tackle being introduced at ICAST 2019.

MLF Pro Tips: How to Fish a New Lake

Major League Fishing pros Alton Jones, Jeff Sprague, Anthony Gagliardi and James Watson share their thoughts on how to approach fishing a new lake for bass.

See more Popular Videos

Trending Stories

Other Freshwater

3 Deadly Bait Rigs For Stripers

J.B. Kasper - April 21, 2005

The colder waters of early spring are prime times to use bait rigs for stripers.

Catfish

Catfish Night & Day: How to Catch 'Em Both Ways

Terry Madewell - April 04, 2018

Catfish tend to be found in shallower water at night, but they are still active during the...

Other Freshwater

5 Great Lures For Bluegills

Stephen D. Carpenteri - March 10, 2011

Who needs live bait when the big 'gills are so eager to strike these lures?

See More Stories

More Stories

Stories

Guns & Loads for Long-Range Coyote Hunting

Stephen D. Carpenteri - December 13, 2015

Predator hunters living in more open areas are in a unique position to enjoy coyote hunting at...

Stories

Game & Fish's Top 10 Stories of 2018

G&F Online Staff - December 24, 2018

From a world-record crappie to the best gear of the year, these hunting and fishing articles...

Stories

Behind the Badge: A Warden's First Night-Poaching Bust

Game & Fish Online Staff - July 30, 2018

Behind the Badge is a regular series of perspective stories by Oklahoma game warden Carlos...

See More Stories

GET THE MAGAZINE Subscribe & Save

Temporary Price Reduction

SUBSCRIBE NOW

Give a Gift   |   Subscriber Services

PREVIEW THIS MONTH'S ISSUE

GET THE NEWSLETTER Join the List and Never Miss a Thing.

×